Trouble Shooting

If your Servo Voltage Stabilizer does not operate properly, please check the following points before calling for service.

Sr. No.	SYMPTOM	CAUSE	REMEDY
1	No Output	No Input Supply	Call Your Electrician
2		Incoming Voltage Is Out Of Range. Servo May Be In Cut-Off Mode	Use By-Pass mode
3		MCB / Fuse May Be Shut-Off / Blown Due To Over Loading	Check Your Load
4	High / Low Output Contact Our Service Voltages	Input Voltage Out Of Range	Contact Our Service Engineer
5		Problem In Control Circuit	Contact Our Service Engineer