main line servo voltage stabilizer main line servo stabilizer unbalance servo voltage stabilizer  
supplier of servo voltage stabilizer


  Trouble Shooting

If your Servo Voltage Stabilizer does not operate properly, please check the following points before calling for service.
SYMPTOM CAUSE REMEDY
No output No input supply
call your Electrician
Incoming voltage is out of range. Servo may be in cut-off mode.
Use By-Pass mode
MCB / Fuse may be shut off / blown Due to Over Loading Check your load
High / Low Output Contact our Service Voltages Input Voltage out of range Contact our Service Engineer
Problem in Control Circuit Contact our Service Engineer

unbalance servo stabilizer.  
 
   

SAFETY INSTRUCTIONS
1.The stabilizer should be installed in a fairy cool and well ventilated place.
2.It should be kept above the floor level as far as possible.
3.The chassis of the stabilizer must be connected to the earthing of the supply.
4.The unit should be installed at the place protected from rain and water